06

Wood, Plastics and Composites

06 05

Common Work Results for Wood, Plastics and Composites

 

LAMCO LFL

Additional information

Green criteria

  • Responsible Sourcing

Product presentation

  • LAMCO LFL®: A 1-1/2” Engineered Wood Product (EWP) in 4 grades: 1.6E, 1.7E, 1.9E & 2.1E
  • Use as a substitute for LVL, LSL, PSL or any MSR or MEL lumber product
  • Made of slow growing Black Spruce, LAMCO LFL is incredibly consistent with low COV’s rivals Concrete and Steel for applications you can trust in
  • Double T&G edge laminated and finger joined to lengths up to 32’-1”
  • Air dried to 12-14% standard or lower as required in our – no heat added process
  • Code Approved uses: Beams, girders, rafters (collar-tie), timber frame and plated trusses

Advantages

  • Approved for use in girder and collar-beam (Ridge board & Collar-Tie)
  • Always straight, it saves you time by avoiding the need to find and align each piece curvature.
  • 100% usable parts = zero waste and money saving
  • Wood cuts done according to conventional methods: bevels, mitres
  • Used with cheap and easy-to-find supports and spill decks
  • Optimized designs with greater on center spacing with no warping, twisting or cracking
  • Less than 1% glue content
  • All residues converted to wood pellets on-site for clean burning heat or livestock beddin

Installation / Delivery

  • Install as you would any conventional lumber products
  • Cutting, Notching, Beveling or Mitering as per all code approved conventional methods
  • Meets all building codes and  standards
  • For LAMCO Products Design Guide: http://www.lamcoewp.com/en/technical-info/
  • Uses affordable conventional framing connectors and anchors.
  • Delivery can be direct from the mill or from Chain of Custody approved distribution partners

Pre-consumer : 0 %

Post-consumer : 0 %

Technical Data documented and validated by : Vertima

Vertima record number : FVERT-14-1057-01-AN

In effect since : May 2014

Last update : October 2014

Final manufacturing site  :

Saint-Felicien, Québec, Canada, G8K 0A1

 

 

Regional Materials
Components

% Materials extracted, collected,
treated and recovered within a
800 km or 2,400 km radius (depending
on the transportation mean used).

SPF # 2 100 %
MSR 1650 100 %
MSR 2100 100 %
MSR 2400 100 %

 

Technical Data documented and validated by:Vertima
Vertima record number: FVERT-14-1057-01-AN
In effect since: May 2014
Last update: October 2014

 

VOC

 

Adhesives applied in the factory and VOC:

 

Type    

 

Name of product

 

VOC CONTENT-g/L

Wood adhesive M172L 0 g/L
Emulsion XB90K5LF 42,06 g/L

 

Technical Data documented and validated by:Vertima
Vertima record number: FVERT-14-1057-01-AN
In effect since: May 2014
Last update: October 2014

LEED Canada-NC & CS 2009

MR 7 – FSC Certified wood 

MR 5 – Regional material

Technical Data documented and validated by:Vertima
Vertima record number: FVERT-14-1057-01-AN
In effect since: May 2014
Last update: October 2014

Information request

  • This field is for validation purposes and should be left unchanged.